Fluke 773 Milliamp Process Clamp Meter

Fluke 773 Milliamp Process Clamp Meter Milliamp process clamp meters can measure mA signals without breaking the loop. The Fluke 773 mA Clamp Meter is Fluke’ s premier mA Clamp Meter, providing you with the best in troubleshooting and process calibration power. Need more hours in your day? Save time by NOT breaking the loop on 4-20 mA signal measurements. Are you spending time: • Taking mA measurements by removing a wire and breaking the loop • Calling the control room to isolate a loop • Testing analog input/ output on a console • Troubleshooting devices with mA inputs and outputs • Repairing intermittent or erratic 4-20 mA loops • Going back to the shop to get extra tools If you need more time in your busy day take a good look at the Fluke 773 mA Clamp Meters. It’ s designed to save you time, and money, by eliminating time wasting activities. Now you can troubleshoot and repair 4-20 mA loops without breaking the loop or bringing down the system. The 773 mA Clamp Meter features: • Best in class 0.2 % accuracy • 0.01 mA resolution and sensitivity • Measure 4 to 20 mA signals without ” breaking the loop” • Measure mA signals for PLC and control system analog I/ O • Dual backlit display with both mA measurement and percent of 4 to 20 mA span • Measurement Spotlight illuminates hard to see wires in dark enclosures • Detachable clamp with extension cable for measurements in tight locations • Measure 10 to 50 mA signals in older control systems using the 99.9 mA range • Automatically change the 4 to 20 mA output for remote testing • Power saving features, auto-off, backlight timeout extend battery life • Hold function captures and displays changing measurements • Measure 4 to 20 mA signals with in-circuit measurement • Simultaneous mA in-circuit measurement with 24V loop power for powering and testing transmitters • Source 4 to 20 mA signals for testing control system I/ O or I/ Ps • mA output linear ramp or 25% step output • Automatically change the 4 to 20 mA output for remote testing • DC voltage measurement to verify 24V power supplies or voltage I/ O signals • Source DC voltage to test input devices that accept a 1-5V or 0 to 10V signals • Scaled mA output provides a continuous mA signal that corresponds to the 4 to 20 mA signal measured by the mA clamp • Enables milliamp signal logging to a separate logging device without breaking the loop • Output mA signal enables a logging DMM or other device to record the 4- to 20 mA signal without breaking the loop • mA in/ out: simultaneously measure the mA signal with the clamp and source a mA signal • Apply a mA input signal to a device and measure its’ 4-20 mA output on devices such as valves or mA isolators • Voltage output linear ramp or 25% step output • Automatically change the voltage output for remote testing Fluke 773 Milliamp Process Clamp Meter Included accessories: • Four AA alkaline batteries ( installed) • Soft carrying case • TL75 test leads • AC 72 detachable clip • TL 940 mini hook test leads • Instruction sheet • Hanging tool with hook and loop strap